Metric Halo ULN-R - Manual (Page 2)

1) Remove the six screws from the top of the case:
Installing the mic pres:
2) Remove the screws from the left and right sides of the case. If the rack ears are fitted, there will be five
screws per side. Please note that the screws on the rack ears are longer than the others. Be sure to put
the longer screws back in the rack ears when you reassemble the LIO-8.
If the rack ears are not fitted, there will be three screws per side.
Remove the top cover, and rotate the unit so that the rear panel is facing you. If you are installing the
Ch. 5-8 kit only, jump to step 9.
3) Remove the two screws holding the Mic In cover plate, then remove the plate from inside the LIO-8.