Meinberg DU35K - Manual (Page 13)

13
Because it is possible to preconnect clocks in different ways it is necessary to set the
jumpers on the main board correctly (see examples Fig.3-6). The factory default
setting of the jumpers is: syncronisation by RS232 time strings.
Rear Panel Connectors
Name Type Signal Cable
IN 25 pin SUB-D RS232 shielded data line
OUT 9 pin SUB-D RS232 shielded data line
ANT BNC 77,5kHz shielded coaxial line
Power power cord receptacle 85-264VAC / power supply cord
120-375VDC
CE Label
This device conforms to the directive 89/336/EWG on the
approximation of the laws of the Member States of the European
Community relating to electromagnetc compatibility.