Meinberg GPS167LCD-MP - Manual (Page 24)

24
SETUP INITIAL POSITION
When the receiver is primarily installed at a new location far away from the last
position saved in the receiver´s memory the satellites in view and their dopplers will
differ so much from those expected due to the wrong position that GPS167 has to scan
for satellites in Warm Boot mode. Making the new approximately known position
available to the receiver can avoid Warm Boot and speed up installation.
SETUP: INITIAL POSITION
INITIAL POSITION
Lat:51°59’06’’N Lon: 9°13’30’’E Al:110m
SETUP INITIAL TIME
If the receiver´s on-board real time clock keeps a wrong time the receiver is unable to
compute the satellites´ correct elevation angles and dopplers. This submenu enables
the user to change the receiver´s system time for initialization. After the receiver has
locked, its real time clock will be adjusted using the information from the satellites.
SETUP: INITIAL TIME
SET INITIAL TIME MESZ
Date: 18.05.2001 Time: 12:00:00
INIT USER PARMS
This menu lets the user set all parameters back to the default settings. The user has to
acknowledge this menu again before the initialisation starts.
SETUP: INIT USER PARMS
Are you sure ? Press ...
INC => YES MENU => NO