beautypg.com

Reprogramming a single homelink button, Security, Troubleshooting tips – Dodge 2009 Charger User Manual

Page 153: Reprogramming a single, Homelink, Button

background image

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button for

20 seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.

3. Without releasing the button, proceed with Program-
ming HomeLink

௡ Step 2 and follow all remaining steps.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.

To do this, press and hold the two outside buttons for
20 seconds until the EVIC message states “CHANNELS
CLEARED.” Note that all channels will be erased. Indi-
vidual channels cannot be erased.

The HomeLink

௡ Universal Transceiver is disabled when

the Vehicle Security Alarm is active.

Troubleshooting Tips

If you are having trouble programming HomeLink

௡, here

are some of the most common solutions:

• Replace the battery in the original transmitter.
• Press the learn button on the garage door opener to

complete the training for rolling code.

• Did you unplug the device for training, and remember

to plug it back in?

If you are having any problems or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

151

3

This manual is related to the following products: