beautypg.com

Programming homelink – Dodge 2009 Charger User Manual

Page 149

background image

WARNING!

Your motorized door or gate will open and close

while you are training the Universal Transceiver.
Do not train the transceiver if people or pets are in
the path of the door or gate. Only use this trans-
ceiver with a garage door opener that has a “stop
and reverse” feature as required by federal safety
standards. This includes most garage door opener
models manufactured after 1982. Do not use a
garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or as-
sistance.

Vehicle exhaust contains carbon monoxide, a dan-

gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.

Programming HomeLink

Before You Begin
If you have not trained any of the HomeLink

௡ buttons,

erase all channels before you begin training.

To do this, press and hold the two outside buttons for up
to 20 seconds. The EVIC will display “CLEARING
CHANNELS.” Release the buttons when the EVIC mes-
sage states “CHANNELS CLEARED.”

It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink

௡ for more efficient training and accurate

transmission of the radio-frequency signal.

Your vehicle should be parked outside of the garage
while training.

1. Turn the ignition switch to the ON/RUN position.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

147

3

This manual is related to the following products: