Dual XNAV3500P - Manual (Page 13)

XNAV3500P PORTABLE GPS NAVIGATION SYSTEM
11
Time Set
To set the time, touch the ‘TIME SET’ button on the main menu screen. See page 7 for
additional information on accessing the time set screen.
You will see up/down arrows over/under the first set of double figures; these will increase or
decrease the ‘hours.’ Up/down arrows over/under the next two single-digit figures adjust the
minutes. A small AM/PM section is at far right; touching it will toggle between the two. Touch
the ‘OK’ button to save the time and exit, or undo the change by tapping ‘Cancel ’.
Calibrate
If the touch screen of your device is operating incorrectly, you can adjust it with the
‘CALIBRATE’ mode. Touch the ‘CALIBRATE’ icon on the main menu screen. See page 7 for
additional information on accessing the calibrate screen.
To begin the calibration, tap and hold the center of the target. When the target moves to
another position, tap and hold again. Repeat the same step to complete the adjustment. Once
the calibration is complete, a new screen with a message reading “New calibration settings
have been measured” will appear. If you want to keep the changed settings, tap the screen, or
press the NavAtlas button located on the front to return to the main menu.