Directed Electronics 259D User Manual

Page 18

step 4

Safety Shutdown Wires

With all ignition wires properly connected, find the appropriate

safety shutdown wires. These include the brake wire, hood pin,

and neutral safety wires.

First locate the factory brake wire using your multi-meter. Find

the switch at the top of the metal arm coming off the brake

pedal. There are usually two wires connected to that switch.

Locate the wire color according to the web information. With

your black meter lead still in the kick panel, probe the suspected

wire with the red lead of your meter. With the brake pedal at rest

it should read 0.00 volts. While watching the meter, depress the

brake pedal. The meter should read between 10.00 volts and

13.00 volts. Once you have located the correct brake wire, solder

the small BROWN wire on the secondary harness to it and tape

the connection with electrical tape.

important! Do not use the vehicle until you confirm the
operation of the brake shutdown.

important! These wires are meant to protect the vehicle
and anyone near the vehicle. They must be connected
appropriately to prevent damage to the vehicle and possi-
ble bodily injury. Failure to properly install these wires may
cause the vehicle to lunge if remote started while in gear.

➜