Directed Electronics 259D User Manual

Page 16

If the vehicle requires more than one ignition as per the Web site

information follow the same test procedure and solder the thick

PINK/WHITE wire to it and be sure to cover your connection

with electrical tape. If your vehicle requires more than two igni-

tions, contact Rattler Technical Support.

step 3

Accessory and Starter wires

The starter and accessory wires will be located in the same harness

as the ignition and constant power. Leaving the meter black lead

connected to the metal ground, take the red lead and probe the

wire suspected to be the accessory. With the key off, your meter

should read 0.00 volts. Turn the key to the on position and the

meter should read between 11.00 volts and 13.00 volts. Now

turn the key to the crank position. If you have the correct wire

the voltage will disappear while the starter is cranking and return

once the key returns to the on position. If the wire tests correctly,

solder the thick ORANGE wire off the relay satellite pack and

secure it with electrical tape. If your vehicle requires more than

one accessory contact Rattler Technical Support.

➜