MBM Corporation 430 EP semi-automatic programmable - Manual (Page 14)

EBA 430 E • EBA 430 EP
-27-
1.
2.
-26-
If the cutting quality decreases:
• Check the cutting depth (see page 34).
• Check the cutting stick (see page 30).
• Replace or grind the cutting stick
(see page 26-34).
The blade may only be grinded by a qualified
workshop or from the manufacturer Krug &
Priester, D-72336 Balingen.
Danger! Risk of injury
The blade is extremely sharp. Do not
dismount or transport the blade without
protection. Changing the blade may only be
performed by trained staff.
Lower the blade by pressing both cutting
buttons (1.). Keep one button pressed and
turn off the main switch (2.).
Turn the blade depth adjustment screw to the
left until it stops (Screwdriver found in tool set).