MBM Corporation 430 EP semi-automatic programmable - Manual (Page 12)

EBA 430 E • EBA 430 EP
-23- -22-
cm
inch
cm
inch
EBA 430 EP
Start machine
•
Main switch F to position "I", insert the key H
for the control panel and turn it to the right.
Open the safety Front guard
A
•
Press S button O ➞ backgauge I moves to
the rear and searches for the reference
position, wait until a measurement of
38,5 cm or 15,16 inch is shown in the
display
D .
Warning!
Before storing or cutting a measurement
please check if the correct measurement
scale (cm or inch) is stored. How to store see
below picture on the left.
Dimensions control - cutting to specified
dimensions
•
Enter dimension at the numerical key pad Q
➞ LED "S" X appears.
•
Press S button ➞ dimension is approached,
➞ LED "S" disappears.
Dimensions below 9 cm can only be
approached with the
S button held pressed.
(When the start button O is released, the
backgauge I moves to a measurement
of 9 cm ➞ measurement 9 cm blinks, now
push again the start button, backgauge I
moves to for example 7 cm).
•
Insert paper and move by means of the
stacking angle to the backgauge
I and side
lay at the left J .
•
Close the safety guard A.
•
Move the pressing lever E to the left by a
slight swing.
•
Release the cutting.
Cut according to markings
•
Adjust the backgauge with the hand-wheel
G to the back.
•
Insert paper and move by means of the
stacking angle to the backgauge
I and left
side-lay J.
•
Turn rotary control G to the right until the
marking on the paper to be cut is below the
cutting line indicator. The further the rotary
control is turned to the right, the faster the
backgauge moves. Return of the backgauge
is quick by turning the rotary control to the
left.
•
Close the safety guard A.
•
Move the pressing lever E to the left by a slight
swing.
•
Release the cut.
Eject function
If the
z button is kept pressed the backgauge
I moves to a measurement of 9 cm (Basic
adjustment) and when released the z button
returns to the measurement last set.
If the
z button is released while the
backgauge moves to the front, the
backgauge stops and moves back to the
measurement which has been set last time.
Cutting activation
Warning!
•
Run backgauge to the front for turning the
paper stack.
•
Do not interrupt the upward movement of the
blade by performing switching procedures.
•
Release blade only when LED "S" has gone
out.
•
Close the front guard A .
•
Blade must always be at the top and be
covered by the clamp. Do not touch the
blade
- risk of injury! (see security
information on page 34).