MBM Corporation 7228 cutter - Manual (Page 16)

- 16 -
IDEAL 7228-95
05-02
08-01
25
Turning or replacing the cutting stick
- Turn the blade depth adjustment (27) to the top
until it stops (spanner in tool set).
- Remove spanner.
Danger! Risk of injury!
- Remove the cutting stick (26) with a small
screwdriver.
- Turn the cutting stick (the non-used side must be
near to the blade) and plug it into the holding bolt.
The cutting stick can be used eight times.
- Place the paper onto the whole width of the cutting
area.
- Lower the blade by pressing both cut keys. Keep
one button pressed and turn off the main switch.
- Lower the blade depth adjustment (27) until the
paper is cut along the entire length.
- Remove spanner.
- Turn main switch to position „ I „.
Cutting test
- If the last sheet of paper is not completey cut,
lower the blade adjustment (27) 1/12 using a
spanner.
- Remove spanner.
- Repeat this procedure until the paper is cut along
the entire length.