MBM Corporation 7228 cutter - Manual (Page 10)

- 10 -
IDEAL 7228-95
04-01
67-03
Multiple cuts function start
- Enter the cut size on the display.
- Press
key.
- Push the paper to the backgauge.
- Release the cut.
- Press
M
key
➞ the red „M“ (12) light will be on.
- Enter the constant cut size.
- Press
key.
➞ the backgauge will advance by the constant cut
size.
Exiting program-mode
- Press
M
key
➞ LED „M“ (12) switch OFF, The
actual size is shown.
3.3 Cutting activation
Danger!
Do not reach into the cutting area when the
blade is in motion.
A cut can only be activated when the specified size
is approached. The LED „S“ on the display must be
deleted and the safety area (38) free.
- Press both buttons of the safety two-handed
control system (1) simultaneously and keep them
pressed until the paper is completely cut.
Cutting stop or interruption:
- Release one or both buttons of the two-hand
control (1).