Dodge 2008 JS Avenger Sedan - Manual (Page 148)

If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink
௡ button is pressed.
If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, proceed to Step 5 “Pro-
gramming A Rolling Code System.”
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
6. Firmly press and release the “Learn” or “Training”
button. The name and color of the button may vary by
manufacturer.
GARAGE DOOR OPENER TRAIN BUTTON
1 — Door Opener 2 — Training Button
146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE