Dodge 2008 JS Avenger Sedan - Manual (Page 147)

Your vehicle should be parked outside of the garage
when programming.
Begin Programming
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLink
௡ button you wish to program.
Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away
from the HomeLink
௡ button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink
௡ button and the hand-held transmitter button
until the HomeLink
௡ indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink ௡
and hand-held transmitter buttons.
Watch for the HomeLink
௡ indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open and close while you train.
NOTE: Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
NOTE: After training a HomeLink ௡ channel, if the
garage door does not operate with HomeLink
௡ and the
garage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 “Programming A Rolling Code Sys-
tem.”
4. Press and hold the just-trained HomeLink ௡ button
and observe the indicator light.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145
3