Maytag MMV5000BDQ Installation - Manual (Page 10)

9
A-2. Install the Mounting Plate
Step. 1 Setup position
a. Draw a line down the middle of the studs(See the Wall Construction, page 5)
b. Draw a vertical line on the wall at the center of the 30” wide space.
NOTE: Use the wall template for the rear wall.
Reference Wall Template prior to proceeding.
Installation of this product require TWO persons.
Step. 2 Drilling
Reference the Wall Template.
Step. 3 Install the damper
Fit the damper into the house duct. Be sure that the damper hinge is on the top and the damper swings
free into the wall outlet.
Step. 4 Tightening the screws
To Attach the mounting plate to the wall using the toggle bolt assemblies and/or lag screws:
Take the 28" foam
tapes and remove
the paper from
sticky side. Press
the sticky side onto
the front edge of the
damper. (Don't
stretch the foam
tape)
Wall
House Duct
Damper
Foam Tape
Mounting Plate