Maytag MMV4184AAW Installation - Manual (Page 17)

17
STEP 6: Attach The Oven To The Wall
1. Carefully lift microwave oven and hang it on support tabs (See
Figure 26 at the bottom of the mounting plate.) Reaching
through upper cabinet, thread power supply cord through the
power supply cord hole in the bottom of the upper cabinet. See
Figure 30.
2. Rotate the microwave oven upward so the top of oven is
against the bottom of the upper cabinet or cabinet frame.
3. Drop the lock pin and washer assembly into hole N (left side
hole) and push the pin down as far as it will go. See Figure 31.
4. Place washers over two 1/4”x3” bolts. Then insert a bolt down
through each hole in the upper cabinet bottom. Tighten the
bolts until the gap between the upper cabinet and microwave
oven is closed. See Figure 32.
5. Remove the lock pin and washer. If wall-vented or
room-vented installation is used, skip to No. 6, 7.
Figure 30
Figure 31
Figure 32
To avoid risk of personal injury or property damage, you will need two people to
install this microwave oven.
W A R N I N G