D-Link DI-707P - Manual (Page 18)

-18-
Enter the proper setting provided by your ISP for the following fields :
WAN IP Address, Subnet Mask, Gateway, Primary and Secondary DNS
2. Dynamic IP Address
•
Host Name: optional. Required by some ISPs, for example, @Home.
•
Renew IP Forever: this feature enables the DI-707P to renew the IP
address automatically when the lease time is expired even if the system
is in an idle state.
3. PPP over Ethernet
•
PPPoE Account and Password : the account and password your ISP
assigned to you. If you don't want to change the password, leave the
password field blank.
•
PPPoE Service Name: (optional) Input the service name if your ISP
requires it.
•
Maximum Idle Time: set the length of “no activity” time at which to
disconnect your PPPoE session. Setting it to “0” will disable this
feature.
4. Dial-up Network
•
Dial-up Telephone, Account and Password: assigned by your ISP. If you
don't want to change the password, keep it empty.
•
Primary and Secondary DNS : automatically assigned if they are
configured as "0.0.0.0."
•
Maximum Idle Time: the length of “no activity” time at which to
disconnect your dial-up session.
•
Baud Rate : the communication speed between the DI-707P and your
MODEM or ISDN TA.
•
Extra Setting: needed to optimize the communication quality between
the ISP and your MODEM or ISDN TA
5. PPTP
Just follow steps below to configure the PPTP WAN type: