Maytag LAT9420AAE Installation - Manual (Page 6)

CHECK LIST
■ ■
Tub block, accessory package and
instructions have been removed from
tub.
■ ■
Washer is properly grounded and
plugged into a polarized electrical outlet.
■ ■
Water is turned on. Check for leaks at
faucet and water valve connections.
■ ■
Drain hose is properly located in drain
facility and hose is not kinked.
■ ■
Washer has been leveled with legs
firmly on floor, leveling legs lock nuts
have been tightened.
■ ■
Fill washer. Check for correct water
temperature.
■ ■
After washer has filled, let washer
agitate.
■ ■
Spin water out.
■ ■
Demonstrate washer usage to con-
sumer. Be sure to leave these instruc-
tions and the User’s Guide with the
STEP 13
• Check machine again with a level.
• Be sure that machine does not rock.
STEP 14
If a separate ground is required by local
codes:
A grounding kit (Part No. 12001875) containing
the ground wire, clamp, ground screw and
washer needs to be purchased. Connect
ground wire to back of unit using the ground
screw and washer. Secure other end of
ground wire with clamp to COLD metal water
pipe.
NEVER CONNECT GROUND WIRE TO
PLASTIC PLUMBING LINES, GAS LINES
OR HOT WATER PIPES.
STEP 15
• Plug power cord into properly grounded
electrical outlet.
STEP 16
• Remove tape from lid.
• Open lid to remove tub block.
• Remove any remaining shipping material,
including protective dial cover(s).
STEP 17
• Check operation using the check list.
• Improper connection of the
equipment-grounding conductor
can result in a risk of electrical
shock. Check with a qualified
electrician or serviceman if you
are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided with the
appliance – if it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
IMPORTANT SAFETY PRECAUTIONS
• To prevent unnecessary risk of fire, electrical
shock or personal injury, all wiring and
grounding must be done in accordance with the
National Electrical Code ANSI/NFPA 70-Latest
Revision (for U.S.) or the Canadian Electrical
code CSA C22.1 – Latest Revision and local
codes and ordinances. It is the personal
responsibility and obligation of the appliance
owner to provide adequate electrical service for
this appliance.
WARNING !