Maytag LAT9420AAE Installation - Manual

Read this before you start…
TOOLS needed for installation:
• Cutting knife
• Channel lock
• Nut driver
• Level
• Crescent wrench
• Screwdriver-flatblade
Proper installation is the responsibility of the purchaser.
SERVICE CALLS PERFORMED AS A RESULT OF POOR INSTALLATION ARE THE
RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
GROUNDED ELECTRICAL OUTLET is required. See Electrical Requirements.
STANDPIPE DRAIN SYSTEM must be able to accept 1 1/2” O.D. drain hose. Standpipe
height of 36” is recommended.
NOTE: Unit is designed to pump efficiently to a height of 8 feet at normal spin speeds.
HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer.
LAUNDRY TUB DRAIN SYSTEMS (for use with Water-Saver Models only). Tub capacity
to hold a minimum of 21 gallons.
WATER HEATER set to deliver 140°F (60°C) hot water to the washer.
PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).
2
3
4
5
1
2
3
4
5
6
PARTS supplied for installation:
• 2 inlet hoses
• 4 hose washers
• 2 hose screens
• 1 cable tie
• Literature package
INSTALLATION ACCESSORY KITS
Part No. Description Application
12001875 Grounding Kit Additional grounding if required by local codes.
12001585 Drain Hose Extension Extends drain hose for drain facilities higher than 4 ft.
12001586 Anti-Siphon Used when an air-tight connection exists between
drain hose and drain facility. Floor drain facilities.
12001599 Small Diameter Standpipe Used when standpipe diameter is too small to
Drain Hose receive end of drain hose.
211692 Non-Slip Disc For painted / sloped basement floors.
204986 Carpet Installation Disc For carpeted floors.
1