Marantz UD7007 - Manual (Page 32)

29
Video resolution
This section is for making the settings for video output resolution. Set them depending on the connected
television.
Press RESOLUTION .
• The resolution is changed as shown below each time RESOLUTION is pressed.
• You cannot set resolution individually for each HDMI output.
• When you press and hold
RESOLUTION with the resolution appearing on the
display, “HDMI Init.” appears on the display and the setting returns to the
default.
• The default settings is underlined.
Auto 480/576i
1080P24 1080P 1080i
480/576P
720P
Source Direct
(Auto)
(1080 progressive, 24-frame)
(Source direct)
(1080 progressive)
(480/576 interlaced)
(1080 interlaced)
(480/576 progressive)
(720 progressive)
• If the video resolution is not set to “Auto”, set it to correspond with the resolution of your television/AV
receiver.
• Images will not be projected normally if the television/AV receiver resolution and this unit’s output
resolution do not match.
• Audio and video will be temporarily interrupted if the power of the connected device currently playing is
turned off, or the input is switched.
• When you change the video resolution of the unit, it takes a few seconds up to about 10 seconds for
validation between the unit and the connected device. Audio/video is not output during this period.
Settings enabled during playback
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion
DVD