Checking the network connection – Marantz UD7007 User Manual
Page 14
11
Connecting to a home network (LAN)
n Checking the network connection
After connection, test the Internet connection with “Connection Test” (
on the SETUP menu.
• If “Network is FAILED.” is displayed in the test, check the IP address with “Network” in “Information”
on the SETUP menu, then set “DHCP” to “Manual” (
).
• The unit can use the DHCP function to automatically set up the network.
• When setting up your network manually, after subscribing to an ISP, make the settings according to
directions in “Network” on the SETUP menu (
).
• If you connect the unit to a network without a DHCP function, conduct IP address and other settings
according to “Network” on the SETUP menu (
• The unit does not support PPPoE. If you subscribe to a service that is set with PPPoE, a PPPoE
compatible router is required.
• When setting up the network manually, consult with your network administrator for the settings to
make.
n Registering the connected device for the network
For playing files stored on a device connected via a network, the device must have the unit registered
in advance.
• For registering, refer to the operation manual supplied with the server.
For Internet connections, use an ISP (Internet Service Provider). Ask your local dealer for details.
NOTE
• Do not connect an NETWORK connector directly to the LAN port/Ethernet connector on your
computer.
• It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a
broadband connection, there is no need to subscribe anew.
• The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.
• marantz assumes no responsibility whatsoever for any communication errors or problems resulting
from customer's network environment or connected devices.
Checking the network connection
After you connect this unit to the router with a LAN cable, use the following procedures to check the
network connection.
1
Press
ON/STANDBY
X
to turn on power to the unit.
• Switch the input source for the TV and AV receiver so that the video output
from this unit is displayed on the TV screen.
2
Press
SETUP
.
3
Use
uio
p
to select “General Settings” – “Network” –
).
The connection test starts.
• If the connection is not established, a message is displayed. Check the
connection settings and connection environment.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion
DVD