Marantz PM6004 - Manual (Page 18)

14
ENGLISH
• RMS Power output
(20 Hz – 20 kHz simultaneous drive of both channels): 45 W x 2 (8 Ω load)
60 W x 2 (4 Ω load)
• Total harmonic distortion
(20 Hz – 20 kHz simultaneous drive of both channels, 8 Ω load): 0.08 %
• Output band width
(8 Ω load, 0.06%): 10 Hz – 50 kHz
• Frequency response
(CD, 1 W, 8 Ω load): 10 Hz – 70 kHz +0 dB, -1 dB
• Dumping factor
(8 Ω load, 40 Hz – 20 kHz): 100
• Input sensitivity/Input impedance
PHONO (MM): 2.2 mV/47 kΩ
CD, TUNER, AUX/DVD, RECORDER: 200 mV/20 kΩ
• Maximum allowable PHONO input level (1 kHz)
MM: 100 mV
• RIAA deviation
(20 Hz – 20 kHz): ±1.0 dB
• S/N (IHF-A, 8 Ω load)
PHONO (MM): 83 dB (5 mV input, 1 W output)
CD, TUNER, AUX/DVD, RECORDER: 102 dB (2 V input, Rated output)
• Tone control
Bass (50 Hz): ±10 dB
Treble (15 kHz): ±10 dB
• Power requirement: AC 120 V 60 Hz
• Power consumption
(UL60065): 150 W
• Power consumption during standby: 0.2 W
• Weight: 7.4 kg (16 lbs 5 oz)
z For the purpose of improvement, the specifications and design are subject to change without notice.
Specifications Index
v A
Adjusting the tone ················································ 9
Adjusting the volume ··········································· 9
Auto standby mode ············································ 12
v B
BALANCE ························································· 4, 8
BASS ································································ 4, 8
Batteries ······························································· 3
v C
Connection
Connecting cables ············································· 6
Connecting players ············································ 7
Connecting recorders ········································ 7
Connecting the speakers ······························· 6, 7
v I
INPUT SELECTOR ············································ 4, 8
v M
Mute ································································· 4, 8
v P
Power cord ··························································· 8
Protection circuit ············································ 6, 14
v R
Remote control ···································· 3, 5, 10, 11
v S
SOURCE DIRECT ············································· 4, 8
Speaker cables ················································· 6, 7
Speaker impedance ········································ 7, 14
Stereo pin-plug cable ············································ 6
v T
TREBLE ···························································· 4, 8
v V
VOLUME ·························································· 4, 8
P
Protection Circuit
This is a function to prevent damage to components
within the power supply when an abnormality such
as an overload or excess voltage occurs for any
reason.
In this unit, the power indicator blinks and the unit
enters standby mode when an abnormality occurs.
S
Speaker impedance
This is certain-rated resistance of the speaker set
to an alternating current and expressed in ohms.
The smaller the impedance, the greater the output.
However, load on the amplifier is increased. Use
speakers whose impedance is supported by this
unit.
Explanation terms
1.PM6004_U_ENG_3rd.indd 14 2011/07/06 16:52:56