Marantz NR1504 - Manual (Page 99)

96
Audio Delay
Default settings are underlined.
While viewing video, manually adjust the time to delay audio output so that the video and audio are
synchronized.
Setting details
0ms – 200ms
• This item can be set within the range of 0 to 100 ms when “Auto Lip Sync” ( vpage 100 ) is set to
“On” and when a TV compatible with Auto Lip Sync is connected.
• Store “Audio Delay” for each input source.
Volume
Default settings are underlined.
Set the MAIN ZONE (room where the unit is located) volume setting.
Setting items Setting details
Scale
Set how volume is
displayed.
0 – 98 : Display in the range 0 (Min) to 98.
–79.5dB – 18.0dB : Display ---dB (Min), in the range –79.5 dB to 18.0 dB.
The “Scale” setting is applied also to the “Limit” and “Power On Level”
display method.
Limit
Make a setting for
maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB)
Off : Do not set a maximum volume.
Power On Level
Define the volume setting
that is active when the
power is turned on.
Last : Use the memorized setting from the last session.
Mute : Always use the muting on condition when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
Mute Level
Set the amount of
attenuation when muting
is on.
Full : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
Audio
M-DAX
Compressed audio formats such as MP3, WMA (Windows Media Audio) and MPEG-4 AAC reduce the
amount of data by eliminating signal components that are hard for the human ear to hear. The “M-DAX”
function generates the signals eliminated upon compression, restoring the sound to conditions near those
of the original sound before compression. It also restores the original bass characteristics for a rich and
expanded tonal range.
Setting items Setting details
Mode
Set the mode for “M-DAX”.
High : Optimized mode for compressed sources with very weak highs (64
kbps and under).
Medium : Apply suitable bass and treble boost for all compressed sources
(96 kbps and under).
Low : Optimized mode for compressed sources with normal highs (96
kbps and over).
Off : Do not use “M-DAX”.
• This item can be set with analog signals or PCM signal (Sample Rate =
44.1/48 kHz) is input.
• “M-DAX” settings are stored for each input source.
• When set to “Off”, the M-DAX indicator on the front panel switches off.
• This cannot be set when the sound mode is set to “DIRECT” or “PURE
DIRECT”.
• This can also be set by pressing M-DAX .
Each time M-DAX is pressed, the setting is changed as shown below.
Off Low
Medium High
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD