Marantz NR1501 - Manual (Page 34)

NAMES AND FUNCTIONS
30
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
ADV
ANCED
OPERA
TION
ENGLISH
ADVANCED OPERATION
TUNER OPERATIONS
(PRESET MEMORY)
With this unit, up to 30 FM and AM broadcast
stations can be preset in the sequence desired.
For each of these stations, the frequency and
reception mode can be stored in the memory as
needed.
AUTO PRESET MEMORY
This function makes it possible to scan the FM band
automatically and store all stations with suitable
signal strength in the unit's preset memories.
1. 2.
1.
2.
1. Hold down the unit's MEMORY button
or the EXIT/MEMO button on the remote
controller for at least two seconds.
“AUTO MEM” appears on the display, and
scanning starts from the lowest frequency.
2.
Scanning automatically stops when all 30
preset memories have been set or when
auto scanning has reached the uppermost
limit of the band.
To stop the auto preset memory operation
at any time, press the unit's MEMORY
button or the EXIT/MEMO button on the
remote controller.
Note
The auto preset cannot be performed for AM
stations. Perform the manual preset instead.
MANUAL PRESET MEMORY
(When performing the operations using the
unit's controls)
2. 4. 3.
1.
Tune into the frequency of the broadcast
station to be set.
(Refer to the section on “MANUAL
TUNING” or “AUTO TUNING”.)
2. Press the unit’s MEMORY button. The MEM
indicator starts blinking on the display.
3. While the MEM indicator is still blinking,
press the
1/2 cursor buttons to select the
preset number.
4.
Press the MEMORY button again to enter
the selection.
The indicator stops blinking, and the
broadcast station is stored in the preset
memory selected.
(When performing the operations using the
remote controller)
2.
4.
3.
1. Tune into the frequency of the broadcast
station to be set.
(Refer to the section on “MANUAL
TUNING” or “AUTO TUNING”.)
2. Press the EXIT/MEMO button on the
remote controller. The MEM indicator starts
blinking on the display.
3.
While the MEM indicator is still blinking,
press the
1/2 cursor buttons to select the
preset number.
4.
Press the EXIT/MEMO button again to
enter the selection.
CALLING PRESET STATIONS
1.
1.
2.
2.
(When performing the operations using the
unit's controls)
1. Press the unit’s 1/2 cursor buttons to select
the preset station to be called.
(When performing the operations using the
remote controller)
1.
Press the TUNE button on the remote
controller twice in succession.
2.
Press the 1/2 cursor buttons to select the
preset station whose programs are to be
heard.
Alternatively, press the numeric buttons to
select the preset station.