DXG Technology DXG 552 - Manual (Page 10)

9
2-3 Loading the Batteries
First, turn the camera off.
Insert 2 x AAA alkaline or Ni-MH rechargeable batteries. Make sure the
batteries are fully charged. If the batteries are low on power, change the
batteries as soon as possible to maintain optimal operation.
If the power level drops below 2.3V (when the battery power indicator
only shows one black block), the flash will be disabled: If the power level
drops below 2.2V (when the battery power indicator turns red) the camera
would automatically shut off.
Slide the battery cover open in the direction indicated by the arrow.
Insert the batteries according to the diagram on the inside of the cover.
Gently close and lock the battery cover.
NOTE: To avoid damaging the battery compartment cover, open and close
the cover gently.
If the battery power indicator only shows one black block, the flash will be
disabled.
When the battery indicator turns red, all recording will be disabled and the
camera will soon shut off.
The Date/Time would be stored for approximately 3 minutes during a
battery change. It is best to double-check the correct Date/Time after the
new batteries have been inserted.