Step 2, wire threading – Luxi Electronics DIY-28DS10 User Manual
Page 4
Website:
www.luxielectronics.com
Email:
Phone: +1 (949) 654-2047
Address: Irvine, CA, USA
HD DIY user manual regular wires
Revision: 2.00
Date: 1/26/2015
US patents: 8002572, 8500489 issued; additional patents issued or pending in multiple countries
1.7
Important!
Twist each drain wire tightly into
a solid wire
1.8 Fan the wires out into two group base on
color coding on page 1
Important tip:
the most common potential
problem in DIY termination is the drain wire
short circuit to the adjacent wire, see the picture
below. If the drain wire is not twisted tightly,
some strands may fall out of the V shaped pin
and touch the next wire at point A. If the end of
the drain wire is not cut cleanly, it may touch the
next wire at point B. Pay extra attention to them
Step 2, wire threading
2.1 Carefully thread the wire one by one thru the
wire holder per the color coding on page 1;
the entrance has counter-sink holes; thread
the 4 drain wires the last, make sure no
strands left out
2.2
Important!
Slide the wire holders as far
inward as they can go for best performance