Dacor PREFERENCE RGC304 - Manual (Page 12)

10
Care and Cleaning
Cleaning the Knobs and Trim Rings
Turn the knobs to the off position to remove the 1.
knobs and trim rings for cleaning or replace-
ment.
Disconnect the cooktop power plug from the
2.
electrical outlet.
Grasp each knob and pull straight up to remove.
3.
The trim rings may be removed for cleaning if 4.
necessary. Take note of the position of each trim
ring before removal. Grasp each trim ring and
pull straight up to remove.
Wash the knobs and trim rings with a solution 5.
of warm soapy water. Dacor recommends hand
dishwashing liquid.
Insert the trim rings into the holes in the posi-
6.
tions noted in step 4. Turn the ring until the
flame icon is in the 9 o’clock position for each
trim ring.
To replace the knobs, align the “D-shaped” 7.
opening on the bottom of the knob with the end
of the valve shaft. Carefully push the knob on
until it stops.
Connect the cooktop power plug to the electrical
8.
outlet.
Cleaning the Optional Griddle
Clean the griddle after each use. Wash it thoroughly
in hot soapy water to avoid stains from grease
build-up. The griddle is coated with a non-stick coat-
ing for easy cleaning. Warm water and liquid deter-
gent are all that are needed for cleaning. Remove
stubborn spots with a non-abrasive plastic mesh
pad. To prevent scratching, do not use abrasives or
abrasive cleaners. Use the soft side of a sponge to
scrub it. Dry it with a lint-free cloth.
Replacing the Grate Feet
The rubber feet on the bottom of the grate supports
can be replaced if they are lost or damaged to pre-
vent damage to the spill tray. If necessary, you may
use a pair of needle nose pliers to pull the feet free
from the grate.
Dacor Part
Number
Description
103712 Grate support foot (4 used per grate)
103475 12” Grate (2 used per cooktop)
103476
10” Grate (model RGC365 only, 1
used per cooktop)
To order parts, contact your Dacor dealer or visit
www.everythingdacor.com.
Flame icon in
9 o’clock
position
Valve shaft
Trim ring
Knob