Dixon DFS 114883 - Manual (Page 8)

8
Handle Assembly
1. Attach backing plate and tube support to hopper
using holes shown in illustration.
2. Connect handle to tube support using pivot pin.
ASSEMBLY
BACKING PLATE
HOLES
BACKING
PLATE
TO HOPPER
UNIT
TUBE
SUPPORT STOP
PIVOT PIN
THREADED TUBE
HANDLE
ADJUSTMENT
NUT
ROD END
ADJUSTMENT
NUT
ROD END
HOPPER FRAME
8059-008
3. Attach threaded rod to hopper and handle. When
connected, adjust threaded tube using adjusting
nuts at both ends. The adjustment will be
complete when handle is pulled forward and
hopper door is fully closed.
4. Adjust handle stop so it goes over the center.