Dolmar EDGING TRIMMER PE-251 - Manual (Page 5)

5
Method of operation
– Only use the Edging trimmer in good light and visibility. During the winter
season beware of slippery or wet areas, ice and snow (risk of slipping).
Always ensure a safe footing.
– Never work on unstable surfaces.
– Remove sand, stones, nails etc. found within the working range.
Foreign particles may damage the cutting tool and can cause dangerous
kick-backs.
– Before commencing cutting, the cutting tool must have reached full working
speed.
Cutting Blade
Employ only the correct cutting blade for the job in hand.
Inspect the entire unit for loosing, missing and damage of the parts (especially
the cutter blade). Never use cracked, deformed or damaged cutting blade.
Maintenance instructions
– The condition of the cutter of the protective devices and also of the shoulder
strap must be checked before commencing work. Particular attention is to
be paid to the cutting blade which must be correctly sharpened.
– Turn off the engine and remove spark plug connector when replacing or
sharpening cutting blade, and also when cleaning the cutting blade.
Never straighten or weld damaged cutting tools.
– Operate the Edging trimmer with as little noise and contamination as possible.
In particular check the correct setting of the carburetor.
– Clean the Edging trimmer at regular intervals and check that all screws and
nuts are well tightened.
– Never service or store the Edging trimmer in the vicinity of naked flames.
– Always store the Edging trimmer in locked rooms and with an emptied fuel
tank.
Observe the relevant accident prevention instructions issued by the relevant
trade associations and by the insurance companies.
Do not perform any modifications on the Edging trimmer as this will endanger
your safety.
The performance of maintenance or repair work by the user is limited to those
activities as described in the instruction manual. All other work is to be done
by an Authorized Service Agent. Use only genuine spare parts and
accessories released and supplied by DOLMAR.
Use of non-approved accessories and tools means increased risk of
accidents.
DOLMAR will not accept any liability for accidents or damage caused by the
use of non-approved cutting blade and fixing devices of cutting blade, or
accessories.
First Aid
In case of accident make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid
box.
When asking for help, please give the following information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name
Packaging
The DOLMAR Edging trimmer will be delivered in two protective cardboard
boxes to prevent transport damage. Cardboard is a basic raw material and is
therefore consequently reusable or suitable for recycling (waste paper
recycling).