LD Systems LAX 6 D - Manual (Page 6)

6
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
INSTALLATION AND CONNECTION
Now that you have familiarized yourself with the functions of the LAX6/LAX6D, you should have no trouble using
it. Nevertheless, we recommend that you read the following section carefully. It contains important information
about how to obtain the best results with your mixer.
- Before connecting mics or instruments, make certain that the channel and
MAIN MIX level knobs of the LAX6/LAX6D mixer are set to minimum (all the way to the left).
- Make certain that all external devices such as mics, power amplifiers, speakers,
effects processors, etc. are connected properly.
- When running cables, take care not to injure anyone or
damage the equipment.
4FUUIF&2DPOUSPMT )*
.*%
-08UPUIFNJEEMFQPTJUJPO
- Set the panorama and balance knobs to the middle position.
- Adjust the input gain (TRIM) controls of the individual channels, while
speaking into each connected mic (speech or vocals) or playing the instrument, and ensure
that the peak LED of the corresponding channel comes on only occasionally. This will ensure
that there is always enough headroom and dynamic range available.
- You can shape the sound of the individual signals using the respective channel equalizer.
- Repeat this sequence of steps for all of the input channels being used, always keeping an eye on the LED
level meter (OUTPUT LEVEL) so that it does not swing too far into the red area.
AUDIO CONNECTIONS
XLR and 6.3 mm TRS sockets are available on the LAX6/LAX6D mixer for maximum flexibility. The various ways
of connecting your equipment are described below.
WIRING CONFIGURATION
The XLR and 6.3 mm TRS connectors of the LAX6/LAX6D mixer permit balanced and unbalanced connections
depending on the equipment connected. Examples for wiring your system:
INSTALLATION: