Dynacord DTI 2000 - Manual (Page 7)

DTI 2000 Manual e EDITED.doc 7
than the specified maximum connection timeout setting allows. If the caller does not enter any
new selection during the connection timeout, the DTI 2000 automatically finishes the momentary
announcement and releases the PA-system. Afterwards, the telephone connection is disconnected
as well.
Switches 1 – 4 are used to set the maximum timeout for a connection as indicated in the following
table:
SW1 SW2 SW3 SW4 TIMEOUT
OFF OFF OFF OFF OFF
ON OFF OFF OFF 20 sec.
OFF ON OFF OFF 30 sec.
ON ON OFF OFF 45 sec.
OFF OFF ON OFF 60 sec.
ON OFF ON OFF 75 sec.
OFF ON ON OFF 1.5 min.
ON ON ON OFF 2 min.
OFF OFF OFF ON 2.5 min.
ON OFF OFF ON 3 min.
OFF ON OFF ON 3.5 min.
ON ON OFF ON 4 min.
OFF OFF ON ON 5 min.
ON OFF ON ON 6 min.
OFF ON ON ON 8 min.
ON ON ON ON 10 min.
CAUTION:
The DTI 2000 is factory pre-set to a
maximum connection timeout of 1.5
minutes (SW1 = OFF, SW2 = ON, SW3 =
ON, SW4 = OFF).
Setting the switches 1 – 4 to their OFF-
position specifies an infinite timeout, i.e. the
connection is not automatically
disconnected.
Switches 5 – 8 are not in use and should be left in their OFF-position.
3. Rack installation
There are two rack-mounting options for the DTI 2000. Use the MCP-2 rack installation kit for
installing a single DTI 2000 and the MCP-1 for installing two units next to each other in a rack
system. The following diagram shows both options.
4. Connections
4.1 Connecting the DPM 4000 System Manager