Datamax M-Class Mark II M-4206 User Manual
Page 29
M-4206
23
19) ALIGN LENGTH
Leading edge distance of two
successive labels. Must be entered if
‘LABEL ALIGNMENT’ is set to
Yes (see Section 4.6).
Possible Values:
0 – 999; default =100*
(Units = .01 inch)
20) STOP LOCATION
Sets label stopping (and in certain cases the starting)
location for different printer configurations.
Possible Values:
* AUTO (Automatically sets the stop location. Installed
options will be ‘auto-sensed’ and the
appropriate stop position will automatically
be set. Host commands are ignored.)
HOST
(Sets stop position according to options
installed. If no options are installed the printer
sets stop location to the next label’s start of
print. Host commands will override.)
21) INPUT MODE
Selects between the standard or
template interpretation of incoming
data.
Possible Values:
* DPL (printer constructs the label
using the standard DPL
commands)
LINE (printer constructs the label
using a preloaded template
form)
22) DPL EMULATION
This instructs the firmware to process specific DPL data
(Start of Print, DPI, and Imaging function) according to
the selected printer emulation.
Possible Values:
* STANDARD
ALLEGRO (Allegro Emulation)
P PLUS (Prodigy Plus Emulation)
PRODIGY (Prodigy Emulation)
23) HEAT
Controls the ‘burn-time’ of the printhead. This is the equivalent of
Heat Setting on most label software programs.
Possible Values:
Range: 0 – 30; default = *10
;
Note: All of the menu items listed in the previous section are stored in non-volatile memory.