Lacava EX03 - Manual (Page 5)

LACAVA LLC 5
Installation Instructions/Instrucciones de Instalación
Step 2 - Connecting the water supply
1. Fit the flexible pipe coming from the
base to the solenoid valve housing.
2. Fit the water supply inlet to the adapter at
the solenoid valve housing.
Inlet and outlet should follow the indicating
arrow at the solenoid housing.
Note: Make sure the filter is located at the
solenoid inlet.
3. Connect the cable coming from the
electronic unit to the solenoid valve.
Important:
f i x t u r e was supplied with a Self
Adjusting Sensor. The ideal sensor range for the specific location will be set
automatically.
Before proceeding to step 3 check that
no objects are in front of the sensor
besides the washbasin.
Now, remove the protecting sticker that
covers the sensor.
Step 3 – Connecting the power source
1. For fixture transformer: Connect the other cable coming
from the electronic unit at the fixture base to
the transformer. Plug the transformer into the
electricity socket.
2. After you have connected the power source
(Transformer) wait 15 seconds in order
to allow the system to set the ideal sensor range.
As an indication that the self adjusting is taking place,
a red light in the sensor eye will flash continuously.
The solenoid valve will be opened and closed for 1
second as an indication that the ideal sensor range
was set and the product is ready for use.
3. Turn on the central water supply. Check for leaks.
Note: The fixture includes a special aerator that allows you to adjust
the water stream direction on site in order to prevent water
splashing if needed. To change the angle of the water stream ,
simply move the adjustable tilting plate by pressing it smoothly.
ATTENTION! The aerator is tightened to prevent removal by hand.