Lacava EX03 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
Preparation for installation
Flush water supply lines thoroughly before installing the faucet. Do not
allow dirt, Teflon tape or metal particles to enter the faucet. Shut off
water supply.
Warning
1) To avoid reflection problems keep
a distance of more than 11 3/4”
(300 mm) between the sink and spout.
2) This faucet model, with an infrared
sensor pointing down, is not intended
to be used together with a sink of a
reflective material such as stainless
steel.
3) If a sink strainer is straight below
the faucet sensor, use a strainer with
a non reflective finish (do not use a
chrome plated one).
Step 1 – Installing the faucet
1. Shut off the water supply
2. Drill a hole 7/8” (24mm)
at the place where you want to install the spout of
the tap.
3. If your model includes an optional anti-rotation pin, drill a small hole just
above the previous one for the anti-rotation pin.
4. Insert the spout and its attachments through the wall. The aerator must
face the washbasin.
5. Insert the anti-rotation pin into the small hole (if needed)
6. Fix the base behind the wall with the hexagonal nut and the disk.
11 3/4”
1/8”
7/8”
9/16”
2”