Lacava 4282 - Manual (Page 3)

LACAVA LLC
®
Page 3 of 7
Installation Instructions for Wall-mounting Sinks
1. In order to provide proper support for wall-mounting a sink, it's usually necessary
to remove a small section of drywall so you can access the wall studs and attach
blocking between them.
2. Based on the sink’s dimensions and mounting height (usually 30-33 inches above
floor), decide where support will be needed.
3. Remove the drywall in that area and install 2-by-6 or 2-by-8 blocking between the
wall studs. Then using 3 1/2” galvanized common nails, toenail the blocking to
the studs and repair the drywall.
4. If the studs cannot be used then ¾” plywood support behind the finished wall can
also provide the necessary support.
5. Place the sink onto the desired
position on the wall and mark the
wall through the mounting holes
on the sink. Then drill pilot holes
for the mounting bolts, using a
masonry bit if the wall is tile.
6. Screw the wood threaded part
of the mounting bolts into the
pilot holes so that the machine
threaded portion is sticking out of
the wall.
7. Install the faucet and drain
assemblies onto the sink.
8. Place the sink onto the mounting
bolts, making sure that the sink is
positioned properly and
completely level.