Single models, Services specifications, The cavity – DCS DS224 User Manual
Page 5: Warning, Important, 4jef7jfx
WATER CONNECTION
Recommended HOT
(Maximum 140°F/60°C).
Supplied hose to suit
3
/
8
” male
compression fitting.
WATER SOFTENER MODELS
Refer to your DishDrawer®
User Guide
for how to set up your water softener.
WATER PRESSURE
DRAIN CONNECTION
Drain Hose Joiner to suit Ø
3
/
4
” ±
5
/
64
” and Ø
5
/
8
” ±
5
/
64
” waste tees.
ELECTRICAL CONNECTION
110-120 VAC power outlet, 4.5 Amps Minimum.
WEIGHT
Full 107 lb (48kg) Prefinished
Empty 76 lb (34kg) Prefinished
SINGLE MODELS
w
NN
%SBXFS0QFO
NN
w
NN
NN
NN
w
NN
w
NN
5BC
4JEF7JFX
VÕÌiÀÌ«
ÃÌÕÀi
«ÀÌiVÌ
Ì>«i
w
NN
w
NN
+
.JOJNVN
UIJDLOFTTPG
DBWJUZTJEFT
JT
w NN
×
w NNTFSWJDFT
IPMFJNNFEJBUFMZ
BEKBDFOUUPDPSOFS
DBOCFFJUIFSTJEF
+
+
+
.PJTUVSF
1SPUFDUJPO5BQF
w
NN
w NN
w NN
UISPVHIPVUDBWJUZ
w
NN
w
NN
w NN
w
NN
R
SERVICES SPECIFICATIONS
LENGTH OF SERVICES
(FROM PRODUCT EXIT POINT)
Drain hose - 88
9
/
16
” (2250mm)
Inlet hose - 68
7
/
8
” (1750mm)
Power supply cord - 44” (1125mm)
NOTE: Services approximately exit product 7
7
/
16
” (189mm) from left;
21
5
/
8
” (550mm) from front; 15
1
/
2
” (393mm) from top.
Maximum
Minimum
Water Softener Models
145 p.s.i. (1000kPa)
14.5 p.s.i. (100kPa)
Other Models
145 p.s.i. (1000kPa)
4.3 p.s.i. (30kPa)
THE CAVITY
NOTE: All depth measurements are taken
from the front face of the adjacent cabinetry.
WARNING!
Be sure the edges of the services hole
are smooth or covered. If the services
hole is through a metal partition the
hole must be protected with the Edge
Protector provided to prevent damage to
the power cord or hoses.
NOTE: To align drawer front to adjacent
cabinetry, the product to countertop
clearance can be increased from
1
/
8
” (3mm).
Important!
Adjacent cabinetry must
not extend above
cavity base.
5
R
These marks indicate mounting
screw tab locations
(refer to step 1 page 7)
*
* Depth of product excludes
Curvature
3
/
8
” (10mm) and Handle.