La Crosse Technology WS-3510 - Manual (Page 12)

8
Default Settings
(Factory Reset) → Allows a reset of all weather data from the non-volatile buffer memory (EEPROM)
and reset of all set and/or stored values to the factory settings set prior to shipment → Acknowledge with ٭CONFIRM٭.
Note:
It will take about 5 minutes for the factory reset process. During this period, the text “Factory Reset In Progress” will be
shown. After the reset process is finished, the LCD will switch off and the text “Remove Battery” will be displayed.
Remove the battery and perform system start again. See “3 - Putting in Operation” paragraph.
Leave the basic settings procedure (Setup Mode) with ٭EXIT٭.
5
Display of stored Min/Max Values and Alarm Value Settings
The selected values are simultaneously displayed and flashing in their respective display sections when showing the
coinciding min/max value.
To recall the measuring and alarm values the menu shown below will have to be activated by touching the touch-screen in
the center of the text display section (last two lines at the bottom of the LCD). The display of the values is started by
touching the displays ٭MINMAX٭ or ٭ALARMS٭.
When ٭MINMAX٭ is selected the below shown menu step is activated, which in turn leads to the displays of the stored
Min/Max values by use of ٭MIN٭ / ٭MAX٭ field.
Note:
During individual display of the stored Min/Max values the top line of the LCD screen will automatically display the
time and date of the record.
The following menu item will appear upon touching the display ٭ALARMS٭. By selecting *LO AL* or *HI AL* the unit will
display the set low and high alarm values. These values can be directly selected individually.