13 4.8 time keeping mode, 9 time keeping mode – La Crosse Technology K2-100 User Manual

Page 5

Altimeter Graph Display

4.8 Time Keeping Mode

- Setting the UPV for the Timer and the Timer Counting Display

UPV and Timer Counting Display Setting Sequence

Timer Display

digits have been
selected (flashing)

User Pre-set Value (UPV)

Setting Display

C (Celsius)

m (Meter)

C (Celsius)

ft (Feet)

F(Fahrenheit)

ft (Feet)

F (Fahrenheit)

m (Meter)

hold

lap/reset

hold

lap/reset

hold

lap/reset

hold

lap/reset

Unit Selection Sequence

Graph Scale Display

24 Hour Memory Display

Altitude Setting Sequence

To view the memory

by forward scrolling

(from -24 hour to -15 min.

To view the memory

by backward scrolling

(from -15 min. to -24 hour)

To Set the UPV and the Timer Counting DIsplay

Press and hold the [adjust] button for 2 seconds to
change the display from Timer Display to User Pre-set
Value Setting Display.

T h e h o u r d i g i t s f l a s h o n t h e d i s p l a y b e c a u s e i t i s
being selected.

The setting procedure

Press [adjust] button to change the selection as in the
User Pre-set Value Setting Sequence.

While digits are being selected (flashing), press the
[start/stop] button to increase the number; press the
[lap/reset] button to decrease the number. Hold down the
button to change the number at a higher speed.

- W h e n t h e F L A S H I N G P A R T m o v e s t o " R E P E A T " o r

"COUNT " character, just press [start/stop] or [lap/
resst] button to select the Countdown timer or Repeater
timer.

After you set the timer, press the [mode] button to exit
the setting sequence.

- If no button is pressed in the setting display for about 3

m i n u t e s , t h e K 2 - 1 0 0 w i l l r e t u r n t o t h e T i m e r M o d e
automatically

hour

second

minute

Timer Counting Display

(Countdown Timer or

Repeater Timer)

adjust

To Use the Timer

When the Timer is set, press the [start/stop] button to
start the timer. Press the [start/stop] button again to stop
the timer.

The time to 'Zero' will be shown on the display.

The timer starts to beep every second when it is 5
seconds from the end of the countdown.

- When the countdown time is reached, a long beep that

lasts for 2 seconds will be heard.

Pressing any button in this period will terminate the beep
sound prematurely.

- The user preset time will be loaded automatically at the

end of the beep sound.

To Reset the Timer

Press and hold the [lap/reset] button for 2 seconds to
reset the timer after it has stopped.

4.9 Time Keeping Mode

- Using the Timer

Timer Display

(Timer sets as 1 minute)

Counting Display

Stop Counting Display

Counting Display

digits start
counting

digits stop
counting

digits start
counting
again

start/stop

hold

lap/reset

5.0 Altimeter Mode and its sub-displays

5.0 Altimeter Mode and its sub-displays ...

continue

Altimeter Graph Display

adjust
button

hold

lap/reset

mode

button

hold

adjust

lap/reset

button

adjust
button

mode

button

start/stop

lap/reset

mode

button

mode

button

hold

adjust

hold

adjust