Kussmaul Electronics 091-9-1000 - Manual (Page 4)

CAUTION
This battery saver output is a full wave
rectified sine wave. The 12.5 volts D.C.
has a peak value of approximately 17.5
volts.
It is recommended that the loads are not
highly capacitive. A large capacitor on
the load terminal will "peak detect" the
output and create a voltage of apporxi-
mately 17 volts. This voltage may be too
high for the component connected.
It is suggested that the installed check
the output of the battery saver (when op-
erating with A.C. input) and determine as
each load is connected that the voltage
does not rise. Any load that creates an
increase in voltage should not be con-
nected to the battery saver but rather be
connected directly to the battery.