Kussmaul Electronics 091-175 - Manual (Page 2)

INTRODUCTION
The Auto Charge 24/12 HO, Model 091-175, Battery Charger is a compact completely
automatic charger designed for installation on vehicles with a 24V and 12V battery. The
voltage of the battery connected to the Auto Charger 24/12 HO is sensed via the charging
cables so that the battery is charged according to its requirements. An optional remote
display provides continuous indication of the charger output.
Construction of the Auto Charge 24/12 HO is extremely rugged to withstand the shock and
vibration normally encountered by vehicle mounted equipment. The unit operates com-
pletely automatically and stops charging the batteries when they are fully charged. There is
no trickle charge and therefore no danger of overcharging and water boil-off. Any parasitic
loads on the battery such as radio, lights, etc., are automatically supplied with current by the
charger.
INSTALLATION
The Auto Charge 24/12 HO, Model 091-175 Automatic Battery Charger should be installed in
an area with adequate ventilation. A power cord is supplied for connection to shore line.
1. Mount the charger using the four holes located in the front and rear of the charger.
2. Connect the wiring from the battery to the Output Terminal Strip. Ferrule lugs that
have been securely crimped or soldered should be used.
3. Double check all wiring before proceeding.
4.Pilot light will light to show that the charger has power.