Kussmaul Electronics 091-18WP-120 User Manual
Page 3
III. WIRING THE AUTO EJECT WP
1. Connect one terminal of the solenoid on the Auto Eject WP to the vehicle ground. Use a minimum
of 16 AWG wire.
2. Connect the other solenoid terminal to the vehicle’s starter and install a 4 Amp Fuse inline. Use
a minimum of 16 AWG wire.
3. Crimp the ring lugs on the wire and connect the Green, Black, and White power wires to the ac-
cessories on the vehicle. For Model #’s: 091-18WP-012 and 091-18WP-120, use a minimum of
14 AWG wire. For Model #: 091-20WP-120, use a minimum of 12 AWG wire.
I
V. FIGURE 2, WIRING THE AUTO EJECT WP
1. Note: Connect the starter circuit so that the solenoid is energized only while the
engine is cranking. If the solenoid is energized continuously it will OVERHEAT and
BURN OUT and void the warranty.
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
3