KIP KIPFold 2000 - Manual (Page 24)

KIPFold 2000 User Guide
No part of this publication may be copied, reproduced or distributed in any form without express written permission
from KIP.  2013 KIP. All references subject to change without notice
- 23 -
Location 3: Cross Folder errors
82 Sensor errors on start-up
82:01 Sensor LB10 cut
82:02 Sensor LB11 cut
82:03 Sensor LB12 cut
84 Time out errors
84:01 No paper at sensor LB10
84:02 No paper at sensor LB11 or LB12
84:03 Jam at FF exit at sensor LB8
84:04 Jam at sensor LB11 or LB12
84:12 Jam between sensors LB11 or LB12 and CF exit sensor LB14
84:13 Jam at CF exit sensor LB14
Location 4: Tab Applicator
41:01 Tab unit is not ready
41:02 Error on motor end stage
41:03 No tape inside the unit or sensor is damaged
41:04 Jam close to the knife
41:05 No tab unit is installed