Daewoo L510B1 - Manual (Page 8)

6
◆ Diode Removal/Replacement
1. Remove defective diode by clipping its leads as close as possible to diode body.
2. Bend the two remaining leads perpendicularly to the circuit board.
3. Observing diode polarity, wrap each lead out of the new diode around the corresponding lead on the
circuit board.
4. Securely crimp each connection and solder it.
5. Inspect the solder joints of the two “original” leads on the circuit board copper side. If they are not
shiny, reheat them and apply additional solder if necessary.
TECHNICAL INFORMATION
a
Panel Size 15-inch (38 cm) diagonal
Pixel Pitch 0.297 x 0.297 mm
Viewing Angle 75°(Right/Left)
70°(up), 70°(down)
Contrast Ratio 350:1 contrast ratio (typ)
Brightness 250cd/m 2 brightness (typ)
Color Filter RGB vertical stripe
Synchronization Horizontal 30 - 62 KHz
Vertical 50 - 75 Hz
Video Bandwidth 80 MHz
Max Resolution 1024 x 768 75Hz
Colors 6 bit (With dithering 16.7M Colors)
Display Area 304.1mm x 228.1mm
Input Signal Video RGB analog (0.7Vp-p, 75ohms)
Sync H/V separate (TTL)
Input Signal Connector 15 pin mini D-Sub
Plug and Play DDC1/2B/CI
Power Source 100-240 Vac, 50/60 Hz (Free Voltage)
Power Consumption 25.5 W
Dimension-W x H x D 390 x 396 x 205 mm (with stand)
390 x 325 x 70.5 mm (without stand)
Weight(net/gross ) 4.6/6.1 Kg
10/13.2 lbs
Power Saving EPA, VESA DPMS, Nutek Compliant
Tilt/Swivel Range Tilt 5° forward, 30° backward
Swivel 90° leftward, rightward
Operating Temperature 10 ~ 40°C /50 ~ 104°F