Kleenmaid KED400 - Manual (Page 9)

REVERSING THE DOOR OPENING
Your dryer is supplied with a reversible door. To change the direction of opening proceed
as follows for your type of door.
Dryers fitted with hinge cover:-
Open the door. Undo screw (A)
remove switch strike (B) and
replace screw. Undo screw (J) and
remove buff e r. Remove screws (C)
and latch plate (D). Remove hinge
cover screw (E). Close the door. Reverse door and fit to dryer
in closed position. Refit
screws (G) and hinge cover
(F). Open the door.
Fit screw (E) to secure hinge
cover. Remove screw (H) at
top of door and refit switch
strike (B) as shown. Refit
buffer (J).
Pull the hinge cover (F)
forwards
to remove it.
Remove two outer screws
(G). Remove door. Fit latch
plate (D) with screws (C).
Dryers fitted without hinge cover:-
Open the door. Undo screw (A)
remove switch strike (B) and
replace screw. Undo screw (J) and
remove buffer. Remove screws (C)
and latch plate (D). Remove hinge
block screws (E). Remove door
from hinge blocks. Remove hinge screws (F)
and hinge (G) and refit to
opposite side as shown. Refit latch plate (D) with
screws (C). Remove screw
(H) at top of door and refit
switch strike (B) as shown.
Refit buffer (J). Fit door to
hinge blocks and secure with
screws (E).