Kleenmaid KED400 User Manual

Page 4

Drain your dryer into a sink or bucket, see
Figure 4.

1. Fix outlet hose to the wall or skirting board if

required with the clips supplied at 50cm intervals.
When fixing outlet hose around corners, ensure a
minimum radius of 10cm and fit two clips as
shown in Figure 3.

2. Cut outlet hose to the length required.

Connect your dryer to an unused sink
drain outlet, see Figure 5.

If a blanking cap or plug is provided:

1. Remove cap/plug (1) and fit connector (2a) (not

supplied).

2. Connect elbow (not supplied) (3a) to connector

(2a).

3. Cut dryer hose (4) to length and insert into hole in

plug.

4. After the first run check the installation for leaks.

5. If water appears under your dryer, check that

the outlet hose is not kinked, blocked or
frozen.

Connect your dryer to a sink drain already
connected to a washing machine or
dishwasher, see Figure 6.

1. Remove washing machine/dishwasher drain

connector (1).

2. Fit elbows (2b & 2c) (not supplied).

3. Connect elbow (3a) (not supplied).

4. Cut dryer hose (4) to length and connect to elbow

(3a) (not supplied).

5. Reconnect washing machine/dishwasher drain (1).

6. After the first run check the installation for leaks.

If water appears under your dryer, check that
the outlet hose is not kinked, blocked or
frozen.

Connect your dryer to a washing machine
standpipe, see Figure 7.

40mm standpipe

1. Cut the drain hose (4) to the length required and

insert into the standpipe alongside the washing
machine hose.

2. After the first run check the installation for leaks.

If water appears under your dryer, check that
the outlet hose is not kinked, blocked or
frozen.

Figure 4

Figure 5

Figure 6