Desa FDCFTP - Manual (Page 26)

www.desatech.com 111244-01F 26
REMOTE
OFF
ON HI
LO
IN OUT
OPERATING FIREPLACE
Continued
Note: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES (MODEL HRC100
SERIES)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 49).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 48 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob Control
Knob
Selector Switch in Remote
Position (Optional Remote Control)
Figure 49 - On/Off Hand-Held Remote
Control Unit
Control Button
Turns Burners
On and Off
THERMOSTAT SERIES (MODEL
HRC200 SERIES)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 50). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Note: Do not leave the hand-held remote in the
AUTO mode close to the fireplace. The radiant
heat from the fireplace will turn off the fireplace.
Ideally, place the hand-held remote in the center
of the room facing towards the fireplace.
Indicator
Light
Figure 50 - Thermostat Hand-Held
Remote Control Unit
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F
Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases or
Decreases
Room
Temperature
in AUTO Mode
Digital Display Shows
Temperature and Settings