Desa FDCFTP - Manual (Page 21)

www.desatech.com 111244-01F 21
2. Reattach screen by placing the notches in the
screen frame over the shoulder screws and
pushing down.
INSTALLATION
Continued
Log
Shoulder
Screw
Screen
Figure 36 - Installing Log and Screen
INSTALLING BRICK LINERS AND
LOG SET AND SCREEN
(Models CDCFNR and CDCFPR Only)
1. Remove packaging from brick liners previ-
ously removed from behind top louver.
2. Place rear brick liner against back of firebox.
The left and right brick liners will hold this
liner in place (see Figure 37). Be sure to hold
the rear brick liner while installing the sides
so it will not fall forward.
3. Install left and right brick liners using brackets
and screws from hardware kit as shown in Fig-
ure 38. Screw the bracket into top of firebox
and against brick liners. Adjust bracket before
tightening screw.
Figure 37 - Installing Rear Brick Liner
Figure 38 - Installing Side Brick Liners
Figure 39 - Installing Log
Left Brick Liner
Brick Liner
Bracket and
Screw
Rear Brick
Liner
Log Set
4. Remove log packaging material and discard.
Gently place log over burner (see Figure 39).
(Do not allow log to contact flame as this will
create sooting.)
5. Insert each rod through ten rings located at
top of screen (see Figure 40).
Figure 40 - Installing Screen for Models
CDCFNR/CDCFPR
Screen
Screen
Rod
Rings
Screen
Assembly
Front Center Hole for
Right Screen Assembly
Back Center
Hole for Left
Screen Assembly