Kleenmaid LTK95 Installation Version 802116R1 - Manual (Page 14)

Installation
802116 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 5: Remove the Shock Sleeves and
Shipping Brace
IMPORTANT: The shock sleeves and shipping brace
MUST be removed from the washer before operation.
Remove front access panel by removing the two screws.
Remove bolts and lockwashers from shipping brace
with 9/16 inch wrench and remove brace. Remove
shock sleeves by pulling on the yellow rope.
Remove label from front side of front access panel and
place on backside of front access panel.
IMPORTANT: The shipping brace, bolts,
lockwashers and shock sleeves should be saved and
MUST be reinstalled whenever the unit is moved
more than four feet. Do not lift or transport unit
from front or without shipping materials installed.
Store the shipping materials in the bag provided in the
accessories bag. Save materials for use whenever the
unit is moved.
IMPORTANT: The shipping materials MUST be
reinstalled whenever the unit is moved. Refer to
Moving Unit to a New Location section for proper
instructions on reinstalling the shipping materials.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
152,4 mm (6 inches) in any direction after shipping
brace has been removed. Shock absorbers may
separate and damage to washer may result. For
leveling purposes, the washer may be tilted a
maximum of 152,4 mm (6 inches) in any direction.
Figure 11
Step 6: Wipe Out Inside of Washer Drum
Before using the washer for the first time, use an all-
purpose cleaner, or a detergent and water solution, and
a damp cloth to remove shipping dust from inside the
drum.
Figure 12
Step 7: Plug In the Washer
Refer to section on Electrical Requirements and plug
washer in.
Figure 13
Step 8: Check Installation
Refer to Installer Checklist on the back cover and
make sure that unit is installed correctly.
H336I
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
2
1
4
3
FLW2053N
FLW2070N