Kleenmaid LTK95 Installation Version 802116R1 - Manual (Page 10)

Installation
802116 8 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 3
Figure 4
Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp and by removing shipping tape.
Find the instructions, on the following pages, that are
appropriate for your type of drain receptacle
(standpipe, sink, wall, or laundry tub). Follow these
instructions to properly install the drain hose.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 3,2 cm (1-1/4 inch) outside
diameter drain hose.
Figure 5
H091I
1 Filter Screen (Screen must be facing
outward)
2 Fill Hose
3 Rubber Washer (Plain)
4 Install this end of hose (blue coupling) to
valve connections at rear of washer.
5 Install this end of hose (white coupling) to
water supply faucet.
FLW2008N
1 Water Supply Faucets
2 Cold Water Connection
3 Hot Water Connection
4 Fill Hoses
1
2
3
4
5
FLW2008N
1 2
3
WATER
MIXING
VALVE
4
FLW2009N
1 Retainer Clamp
1