Kleenmaid RH14 - Manual (Page 8)

Active carbon filter (2 pieces)
This filter dissolves cooking odours.
The active carbon filter must never be
washed.
Model with slider switches panel
The active carbon filter should be changed
every 4 months
when in normal use.
Model with electronic control panel
The active carbon filter should be replaced
every 4 months under normal use
or
whenever
LED 5 indicates the saturation
of the filter
.
Th
e LED flashes to indicate that the active
carbon filters need to be replaced.
This must be done after approximately 160
hours of use.
Once you have replaced the carbon filter,
press button 1 for about 3
seconds until
you hear the acoustic signal
(beep).
The LED 5 will now stop
flashing.
Mounting and replacing the active carbon
filter:
a) Disconnect the hood from the electricity.
b) Remove the metal grease filters (Fig. 1).
c) If the active carbon filters have not been
installed, place one active carbon filter
on each side so that they cover the grates
protecting the rotor on the motor. Then
turn the center handle for the active carbon
filters in the clockwise direction (Fig. 2).
d) If the active carbon filters have already
been installed (covering the grates
protecting the rotor on the motor) and
must be replaced, turn the central handle
in
a counter-clockwise direction until the
active carbon filters are unlocked.
e) Refit the the metal grease filters.
Cleaning
To clean the outside of the
rangehood use a
cloth moistened with denatured alcohol or
neutral liquid detergents. Never use
products containing abrasive substances.
Wipe brushed stainless steel in the same
direction as the brushing to avoid
scratching.
Clean the external surface of the
rangehood
approximately once every 10 days.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp
a) Disconnect the hood from the electricity.
b) Unscrew the light shield (Fig. 3).
c) Replace the damaged lamp with a new
halogen lamp of 20
watt max.
d) Refit the the metal grease filters and the
light
shield.
e) Before calling for repair service
if the
lamps fail to light up, make sure the bulbs
are screwed in tightly.